40w Power Supply for 12VDC Input

Extend lead(s) to 10 meter

Extend lead(s) to 5 meter

Internal volt free contacts to indicate system operational status

Control lamp duty by flow control signal with front panel NO FLOW LED in red (flow switch not included)

Control lamp duty by flow control signal for HDPE chambers. Includes front panel NO FLOW LED in red and Test on (Spring) / Off / Flow Enabled 3-position switch (E-SW-3POS-02). Flow switch not included

Installation of UV monitor into A-type power supply. Must be paired with a sensor accessory.

Bring UV monitor connections to labelled terminals. Main alarm, pre alarm contacts, UV Intensity 4-20mA output.

Install of front panel Local/Off/Remote 3-position switch (E-SW-3POS) and internal remote terminals to provide remote enabling.

Over temperature shut down using contact thermostat (E-THERM-CONT-01) 15 - 95 degrees.

Over temperature bleed valve using contact thermostat (E-THERM-CONT-01) 15 - 95 degrees and wire terminals for solenoid connection. Solenoid sold separately.

Over temperature bleed valve using contact thermostat (E-THERM-CONT-01) 15 - 95 degrees and wire terminals for 24V DC solenoid connection. Solenoid sold separately.

Install of front panel On/Off/Timer 3-position switch (E-SW-3POS) and internal timer relay to provide time based control

NB-IoT cellular device providing automatic notifications when system faults are detected. Subscription or lifetime licence required